Remote Control Commands
R&S
®
SGT100A
343
User Manual 1176.8674.02 ─ 07
Parameters:
<BRate>
float
Range:
400 bps to 250E6 bps
Increment: 0.001
*RST:
100000
Example:
SOURce1:AWGN:BRATe?
queries the bit rate which is used for calculation of the Eb/N0
value from the C/N value.
Manual operation:
See
[:SOURce<hw>]:AWGN:BWIDth
<BWidth>
Sets the system bandwidth. The noise signal at the level which corresponds to the
specified carrier/noise ratio is generated in the bandwidth specified here.
This command is available for modes Additive Noise and Noise Only (
SOUR:AWGN:
MODE ADD|ONLY
).
Parameters:
<BWidth>
float
Range:
1000 to depends on the installed options
Increment: 100
*RST:
3.84E6
Example:
SOURce:AWGN:MODE ADD
SOURce:AWGN:BWIDth 10 MHz
sets a system bandwidth of 10 MHz.
Manual operation:
See
[:SOURce<hw>]:AWGN:BWIDth:NOISe?
This command is available for modes In Additive Noise and Noise Only (
SOUR:AWGN:
MODE ADD|ONLY
) modes, queries the real noise bandwidth.
Return values:
<Noise>
float
Range:
0 to 200E6
Increment: 100
*RST:
0
Example:
AWGN:BWID:NOIS?
queries the noise bandwidth.
Usage:
Query only
Manual operation:
See
SOURce Subsystem
