Remote Control Commands
R&S
®
SGT100A
350
User Manual 1176.8674.02 ─ 07
[:SOURce<hw>]:AWGN:STATe
<State>
Activates or deactivates the white noise (AWGN = Averaged White Gaussian Noise).
Use the command
to define the mode the AWGN gen-
erator is working in.
Parameters:
<State>
0 | 1 | OFF | ON
*RST:
0
Example:
SOURce:AWGN:STATe ON
Manual operation:
See
11.14.3 SOURce:BB Subsystem General Commands
The following section describes the commands for setting the frequency shift and the
phase offset for the signal at the "Baseband" block output.
............................................................................................. 351
................................................................................. 351
[:SOURce]:BB:FOFFset
<Foffset>
Sets the frequency offset for the baseband signal. The offset affects the signal on the
baseband block output. It shifts the useful baseband signal in the center frequency.
Parameters:
<Foffset>
float
Example:
BB:FOFF 2MHZ
sets a frequency offset of 2 MHz.
Manual operation:
See
[:SOURce]:BB:POFFset
<Phoffset>
Sets the relative phase offset of the baseband signal.
The phase offset affects the signal of the "Baseband Block" output.
Parameters:
<Phoffset>
float
Example:
BB:POFF 0.5DEG
sets a relative phase offset of 0.5 DEG for the baseband signal
Manual operation:
See
SOURce Subsystem
