Remote Control Commands
R&S
®
SMA100B
357
User Manual 1178.3834.02 ─ 03
:SENSe<ch>[:POWer]:APERture:DEFault:STATe
<UseDefAp>
Deactivates the default aperture time of the respective sensor.
To specify a user-defined value, use the command
Parameters:
<UseDefAp>
0 | 1 | OFF | ON
*RST:
1
Example:
See
Example "Performing a power measurement with a fixed fil-
Manual operation:
See
:SENSe<ch>[:POWer]:APERture:TIMe
<ApTime>
Defines the aperture time (size of the acquisition interval) for the corresponding sensor.
Parameters:
<ApTime>
float
Range:
depends on connected power sensor
Increment: 1E-9
*RST:
depends on connected power sensor
Example:
See
Example "Performing a power measurement with a fixed fil-
Manual operation:
See
:SENSe<ch>[:POWer]:CORRection:SPDevice:SELect
<Select>
Several S-parameter tables can be stored in a sensor. The command selects a loaded
data set for S-parameter correction for the corresponding sensor.
Parameters:
<Select>
float
*RST:
0
Manual operation:
See
:SENSe<ch>[:POWer]:CORRection:SPDevice:STATe
<State>
Activates the use of the S-parameter correction data.
Note:
If you use power sensors with attenuator, the instrument automatically activates
the use of S-parameter data.
Parameters:
<State>
0 | 1 | OFF | ON
*RST:
0
SENSe, READ, INITiate and SLISt Subsystems
