Remote Control Commands
R&S
®
SMA100B
455
User Manual 1178.3834.02 ─ 03
See
Chapter 5.2.1, "Correlating Parameters in Sweep Mode"
Omit the optional keywords so that the command is SCPI-compliant.
Parameters:
<Linear>
float
Range:
0.001 Hz to (STOP - STARt)
Increment: 0.01
Example:
See
Example "Setup an RF frequency or power sweep"
Manual operation:
See
" Step Linear/Step Logarithmic "
[:SOURce<hw>]:SWEep:RESet[:ALL]
Resets all active sweeps to the starting point.
Usage:
Event
Manual operation:
See
12.16 SYSTem Subsystem
The
SYSTem
subsystem contains a series of commands for general functions which do
not directly affect signal generation.
Example: Retrieving information on network-related settings
SYSTem:COMMunicate:NETWork:STATus?
// 1
SYSTem:PROTection1:STATe 0,123456
SYSTem:COMMunicate:NETWork:IPADdress:MODE STAT
SYSTem:COMMunicate:NETWork:IPADdress "10.113.0.104"
SYSTem:COMMunicate:NETWork:IPADdress:DNS "10.0.2.166"
SYSTem:COMMunicate:NETWork:COMMon:HOSTname?
// "SMA100B-102030"
SYSTem:COMMunicate:NETWork:COMMon:WORKgroup "instrument"
SYSTem:COMMunicate:NETWork:COMMon:DOMain "rsint.net"
SYSTem:COMMunicate:NETWork:IPADdress:GATeway "10.113.0.1"
SYSTem:COMMunicate:NETWork:IPADdress:SUBNet:MASK "255.255.252.0"
SYSTem:COMMunicate:NETWork:MACaddress "08 00 27 a3 a1 70"
SYSTem:PROTection1:STATe 1
SYSTem Subsystem
