Getting Started
R&S
®
SMA100B
48
User Manual 1178.3834.02 ─ 03
(Alternatively, tap the "Home" button to minimize the dialog. The R&S
SMA100B
indicates the "Sweep" dialog as active dialog in the task bar.)
9. To activate the RF signal output, select "Level" > "RF On".
Figure 2-7: Generating a frequency sweep signal
The frequency display indicates the frequencies of the running sweep.
The R&S
SMA100B provides the 6 GHz signal at the RF connector at the front
panel.
2.3.3 Saving and Recalling Settings
To restore the results of our measurements later, we save the instrument settings in a
file.
To save the instrument settings in a file
We assume, a test configuration as described in
Chapter 2.3.2, "Generating an RF
1. Press the SETUP key on the front panel.
2. In the "Setup" menu, select "Settings > Save/Recall".
3. In the "Save/Recall" dialog, select "Operation Mode > Save".
Trying Out the Instrument
