Remote Control Commands
R&S
®
SMA100B
350
User Manual 1178.3834.02 ─ 03
Usage:
Query only
Manual operation:
See
:OUTPut<hw>:PROTection:CLEar
Resets the protective circuit after it has been tripped.
To define the output state, use the command
Example:
OUTP:PROT:CLE
Resets the protective circuit of the RF output.
Usage:
Event
Manual operation:
See
:OUTPut<hw>:PROTection:TRIPped?
Queries the state of the protective circuit.
Return values:
<Tripped>
0 | 1 | OFF | ON
*RST:
0
Example:
OUTP:PROT:TRIP
queries the state of the protective circuit of the RF output.
Response: 0
the protective circuit has not tripped.
Usage:
Query only
Manual operation:
See
:OUTPut<hw>:FILTer:MODE
<Mode>
Activates low harmonic filter or enables its automatic switching.
Parameters:
<Mode>
ON | AUTO | 1
ON|1
Ensures best low harmonics performance but decreases the
level range
AUTO
Applies an automatically selected harmonic filter that fits to the
current level setting.
*RST:
AUTO
Example:
OUTPut:FILTer:MODE AUTO
Manual operation:
See
OUTPut Subsystem
