Remote Control Commands
R&S
®
SMA100B
441
User Manual 1178.3834.02 ─ 03
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL
<Rcl>
Determines whether the current level is retained or if the stored level setting is adopted
when an instrument configuration is loaded.
Parameters:
<Rcl>
INCLude | EXCLude
INCLude
Takes the current level when an instrument configuration is loa-
ded.
EXCLude
Retains the current level when an instrument configuration is
loaded.
*RST:
INCLude
Example:
POW:RCL INCL
Takes the level value from an instrument configuration loaded
with command
Manual operation:
See
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]
<Amplitude>
Sets the RF level applied to the DUT.
To activate the RF output use command
("RF On"/"RF Off").
The following applies
POWer = RF output level + OFFSet
, where:
●
POWer
●
RF output level is set with
●
OFFSet
is set with
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet
Parameters:
<Amplitude>
float
The following settings influence the value range:
OFFSet
Numerical value
Sets the level
UP|DOWN
Varies the level step by step.
The level is increased or decreased by the value set with the
command
[:SOURce<hw>]:POWer:STEP[:INCRement]
.
Range:
(Lev OFFSet) to (Lev OFFStet)
*RST:
-30
Default unit: dBm
Example:
POWer -30
Sets the RF level
SOURce Subsystem
