RF Signal Configuration
R&S
®
SMA100B
67
User Manual 1178.3834.02 ─ 03
This value represents the multiplication factor of a downstream instrument, like for
example a multiplier.
The "Frequency" value displayed in the status bar is the resulting frequency, as it is at
the output of the downstream instrument. The frequency at the R&S
SMA100B RF out-
put is not changed.
See
"RF frequency and level display with a downstream instrument"
Remote command:
[:SOURce<hw>]:FREQuency:MULTiplier
User Variation
Defines and activates a user-defined step width for varying the RF frequency or RF
level with the rotary knob.
If disabled, the step width varies in steps of one unit at the cursor position.
Variation Active ← User Variation
Activates the set user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP:MODE
Variation Step ← User Variation
Sets the user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement]
[:SOURce<hw>]:POWer:STEP[:INCRement]
3.4 RF Level Settings
Access:
1. Select "Level" > "Level".
RF Level Settings
