DVB-C configuration and settings
R&S
®
SMCVB-K157
12
User Manual 1179.4686.02 ─ 01
3.2.1
General settings
Access:
► Select "Input Signal > General".
The dialog provides settings to configure the input signal. Also, it provides physical
layer information for external signals and transport stream (TS) signals. For internal
test signals, you can configure payload and structure of test packets.
Settings:
Source
Sets the modulation source for the input signal.
"External"
Uses a transport stream, that is input at the "TS IN"/"IP Data" inter-
face.
For more information about connecting to the interfaces, see also:
●
"TS IN" interface: Section "Configuring the Global Connectors" in
the R&S
SMCV100B user manual.
●
Chapter 3.7, "Local IP data network settings"
Input Signal settings