DVB-S Configuration and Settings
R&S
®
SMCVB-K167
20
User Manual 1179.1058.02 ─ 02
Table 4-1: IP channel configuration support in broadcast standards
Baseband standard
"IP Channel x"
Baseband standard
"IP Channel x"
"ATSC/ATSC-M/H"
Yes
"T-DMB/DAB"
Yes
"ATSC 3.0"
No
"DVB-S"
Yes
"DTMB"
Yes
"DVB-S2"
Yes
"DVB-T"
Yes
"DRM"
No
"DVB-T2"
Yes
"Audio AM"
No
"ISDB-T"
Yes
"Audio FM"
No
See also:
●
Chapter 5.1.1, "How to Apply an External IP Input Signal"
●
Chapter 4.7, "Local IP Data Network Settings"
Requirements
At your IP source, set the "transport stream packets per internet protocol packet" (TP
per IP) parameter as follows:
●
If TP packet length
= 188 bytes: Set TP per IP to
7
or
6
.
●
If TP packet length
= 204/208 bytes: Set TP per IP to
6
.
We recommend that youFurthermore, we recommend that you use a separate LAN
infrastructure to stream the transport streams via IP to the IP connector of the base-
band board. We recommend that you avoid TS packet losses during IP transmission.
Settings:
...............................................................................................21
Input IP
Activates/deactivates the IP input.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>[:STATe]
Alias
Sets a unique name for the IP connection.
The definition of a name is optional but facilitates identification in the measurement
views. The name input fits maximum 16 characters in ASCII format.
Input Signal Settings
