Remote-Control Commands
R&S
®
SMCVB-K167
52
User Manual 1179.1058.02 ─ 02
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:ADDRess
..............................................53
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:PING
.................................................... 53
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:RESult?
................................................ 53
[:SOURce<hw>]:BB:INPut:IP<ch>[:STATe]
<Alias>
Activates/deactivates the "IP Channel x" as IP input.
Specify the current IP TS Channel with the command
SOURce1:BB:DigStd:INPut:TSCHannel
.
DigStd
stands for the IP TS Channel in
the corresponding broadcast standard.
Parameters:
<Alias>
0 | 1 | OFF | ON
*RST:
0
Example:
See
Example "Configure IP channel 2 properties"
Manual operation:
See
[:SOURce<hw>]:BB:INPut:IP<ch>:ALIas
<Alias>
Specifies an alias, i.e. name for the IP connection.
Parameters:
<Alias>
string
Example:
See
Example "Configure IP channel 2 properties"
Manual operation:
See
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT
<Port>
Sets the port of the input IP data at the "IP Data" connector.
Parameters:
<Port>
integer
Range:
0 to 65535
*RST:
6002
Example:
See
Example "Configure IP channel 2 properties"
Manual operation:
See
[:SOURce<hw>]:BB:INPut:IP<ch>:TYPE
<Type>
Sets the IP input type.
Parameters:
<Type>
UNIcast | MULTicast
UNIcast
Analyzes all unicast IP packets that arrive at the specified port.
See
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT
Input Signal Commands