DVB-S Configuration and Settings
R&S
®
SMCVB-K167
12
User Manual 1179.1058.02 ─ 02
Set To Default
Calls the default settings. The values of the main parameters are listed in the following
table.
Parameter
Value
State
Not affected by the "Set to Default"
Remote command:
Save/Recall
Accesses the "Save/Recall" dialog, that is the standard instrument function for saving
and recalling the complete dialog-related settings in a file. The provided navigation
possibilities in the dialog are self-explanatory.
The filename and the directory, in that the settings are stored, are user-definable; the
file extension is however predefined.
See also, chapter "File and Data Management" in the R&S
SMCV100B user manual.
Remote command:
[:SOURce<hw>]:BB:DVBS:SETTing:CATalog?
[:SOURce<hw>]:BB:DVBS:SETTing:LOAD
[:SOURce<hw>]:BB:DVBS:SETTing:STORe
[:SOURce<hw>]:BB:DVBS:SETTing:DELete
4.2
Input Signal Settings
Access:
► Select "Baseband > DVB-S / DVB-S2 > Input Signal".
The dialog provides access to settings necessary to configure the input signal.
Input signal tasks
The settings allow you to perform the following tasks:
●
●
Displaying information about the selected MPEG TS (e.g. data rate)
●
Configuring the internal MPEG TS test packets or internal IP test packets
Chapter 5.1, "Configuring the Input Signal"
Input Signal Settings