DVB-S Configuration and Settings
R&S
®
SMCVB-K167
21
User Manual 1179.1058.02 ─ 02
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:ALIas
Type
Sets the input signal type.
"Unicast"
Analyzes all unicast IP packets that arrive at the specified "Port".
"Multicast"
When an IP address is in the multicast address range, an attempt is
made to join a multicast group using
Set "Multicast Address" and "Port".
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:TYPE
Multicast Address
Editing requires "Type > Multicast".
Sets the destination IP address (IPv4) of the IP connection.
You can set addresses from "224.0.0.0" to "239.255.255.255".
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:MULticast:ADDRess
Port
Sets the destination UDP port.
autosensing, we recommend that you set a port offset of at least 6
between neighboring IP TS channels.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT
IGMPv3 Source Address
Requires "Type > Multicast".
source address.
If you need to filter the data sent to the multicast address, specify the source address.
A source address different from "0.0.0.0" accepts only data originating from the speci-
fied IP address.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:ADDRess
Ping Source Address
Clicking "Ping Source Address" triggers pinging of the IGMPv3 source address.
If you set a different value from "IGMPv3 Source Address = 0.0.0.0" and click the but-
ton, the software checks if the address is reachable.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:PING
Ping Result
Displays the result after pinging the source address.
If "Ping Result > Ping: Successful", the source address is available in the network.
Input Signal Settings