Crest Factor Reduction Settings
R&S
®
SMCVB-K548
11
User Manual 1179.1293.02 ─ 02
4
Crest Factor Reduction Settings
Prerequisite: An ARB file is loaded and enabled.
Access:
► Select the "Baseband > ARB > Crest Factor Reduction".
The remote commands required to define these settings are described in
Settings:
............................................................................................12
State
Enables the crest factor reduction calculation.
Note:
You cannot activate the crest factor reduction and the notch filter simultaneously.
Enabling the notched filter automatically disables the crest factor reduction.
Remote command:
