Getting Started
Satellite Navigation
24
User Manual 1178.6379.02 ─ 01
............................................................................................... 25
State
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
Remote command:
Set to Default
Calls the default settings. The values of the main parameters are listed in the following
table.
Parameter
Value
State
Not affected by "Set to default"
Scenario
None
Test Mode
Navigation
Simulation Configuration
L1/GPS only
Logging
Off
Remote command:
Save/Recall Scenario
Accesses the "Save/Recall" dialog, that is the standard instrument function for saving
and recalling the complete dialog-related settings in a file. The provided navigation
possibilities in the dialog are self-explanatory.
The filename and the directory, in which the settings are stored, are user-definable; the
file extension is however predefined.
See also, chapter "File and Data Management" in the R&S
SMW user manual.
Remote command:
[:SOURce<hw>]:BB:GNSS:SETTing:CATalog?
[:SOURce<hw>]:BB:GNSS:SETTing:STORe
[:SOURce<hw>]:BB:GNSS:SETTing:LOAD
[:SOURce<hw>]:BB:GNSS:SETTing:DELete
Predefined Scenario
Accesses the standard "File Select" dialog and allows you to select a predefined sce-
nario.
The available test scenarios depend on the installed SW options.
Once a scenario is selected, all parameters (simulated position, satellite configuration,
navigation data, etc.) are configured automatically. The sceanrio name is indicated,
see
General Settings