Signal Generation Control
Satellite Navigation
201
User Manual 1178.6379.02 ─ 01
Marker Mode
Marker configuration for up to 3 marker channels. The settings are used to select the
marker mode defining the shape and periodicity of the markers. The contents of the
dialog change with the selected marker mode; the settings are self-explanatory.
"1PPS/10PPS/
1PP2S"
Marker signal generated at:
●
The start of every second
●
10 times per second or once every 100 ms
●
Once every two seconds
Set the "Pulse Width" in the corresponding field.
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:WIDTh
"Pulse"
Regular marker signal.
To define the pulse frequency, set the divider. The pulse frequency is
derived by dividing the chip rate by the divider; the resuliting "Fre-
quency" value is displayed.
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:DIVider
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:FREQuency?
"Pattern"
Marker signal that is defined by a bit pattern. The pattern has a maxi-
mum length of 64 bits.
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PATTern
"On/Off Period"
Regular marker signal that is defined as on-time and off-time; a
period lasts one on and off cycle.
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:ONTime
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:OFFTime
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:MODE
Marker x Delay
Delays the marker signal at the marker output relative to the signal generation start.
Variation of the parameter "Marker x Delay" causes signal recalculation, regardless of
the indication "Current Range without Recalculation".
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:DELay
Marker Settings
