Perturbations and Errors Simulation
Satellite Navigation
127
User Manual 1178.6379.02 ─ 01
Remote command:
[:SOURce<hw>]:BB:GNSS:SSValues
12.6 Time Conversion Errors Settings
Access:
1. Select "Simulation Configuration > Satellites > GNSS system > SV# > SV Config >
Signals Configuration".
2. Select
"Nav Msg Control > Edit"
.
3. Select
"Nav Msg Content > Config > Time Conversion"
.
Time conversion parameters are read-only and common for all SV of one GNSS
system.
4. To change the time conversion parameters of all GPS SVs for example, select
"SV# > SV Config" >
"Copy Modulation Control to SV-ID = All"
.
Per default, the navigation message parameters are set to values, that correspond
to the values retrieved from the constellation data source.
Changing these values leads to deviation between the simulated and the broad-
casted navigation message and thus deliberated errors. SBAS corrections can be
activated for error compensation.
Available navigation message parameters depend GNSS system and selected
navigation message type.
Settings
............................................................................................. 128
..........................................................................................128
....................................................................................129
......................................................................................... 129
........................................................................................... 130
Time Conversion Errors Settings