Data Logging
Satellite Navigation
174
User Manual 1178.6379.02 ─ 01
"Offline"
The logged navigation data is emulated.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:MODE
Generate,On/Off
Starts/stops data logging.
Note:
Existing files with the same name are overwritten. If you store the logged data to
files, first check whether the selected folder
Store in Subdirectories according Time
empty.
To prevent overwriting, set "Store in Subdirectories according Time > On".
"Generate"
Logging files are created and saved.
"On"
Logging is initialized and logging starts.
"Off"
Logging files are saved.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:OFFLine:GENerate
[:SOURce<hw>]:BB:GNSS:LOGGing:OFFLine:ABORt
[:SOURce<hw>]:BB:GNSS:LOGGing:RT:STATe
Time Offset
In "Mode > Offline", delays the logging start.
The first logged point of time is defines as "Simulation Start Time" + "Time Offset" +
"Log Step".
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:OFFLine:TOFFset
Duration
In "Mode > Offline", sets the time span that is logged.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:OFFLine:DURation
Directory
Access the standard "File Select" dialog and defines the storage place.
See also
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:DESTination:FILE:DIRectory
Store in Subdirectories according Time
Creates subdirectories with time stamp and saves the logged files in them. Enable this
parameter to prevent that files are overwritten.
If logging is enabled, the file names of the created files and the folder structure are
indicated.
See also
Data Logging General Settings