Data Logging
Satellite Navigation
175
User Manual 1178.6379.02 ─ 01
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:DESTination:FILE:DIRectory
[:SOURce<hw>]:BB:GNSS:LOGGing:DESTination:FILE:TAPPend[:STATe]
Logging formats and categories
The logging categories and logging formats are listed in table form.
Each logging category is defined with:
State ← Logging formats and categories
Enables/disables logging of this particular category.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:SATellite:STATe
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:UMOTion:STATe
Format ← Logging formats and categories
Sets the file format in that the logged data is saved.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:UMOTion:FORMat?
Log Step, s ← Logging formats and categories
Sets the logging step, i.e. the resolution of the logged data per format and category.
Example:
A file generated in "Mode > Offline" with "Duration = 60s" and "Log Step = 10s" has six
records per SV ID.
The first one is made 10s after the "Simulation Start Time" + "Time Offset" and the next
steps are made after 10s each.
Observe also the file content of the log file. The first logged parameter
Elapsed_Time_ms
indicates the log steps.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:SATellite:STEP
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:UMOTion:STEP
Configure Logging ← Logging formats and categories
Accesses the "Logging Satellites/User Motion" dialog to configure the messages to be
logged, see
Chapter 15.2, "Configure Logging Settings"
15.2 Configure Logging Settings
Access:
1. Select "Data Generatiom > Data Logging".
Configure Logging Settings