Remote-Control Commands
Satellite Navigation
234
User Manual 1178.6379.02 ─ 01
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:A<ch>:DHEading
..........................................236
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:A<ch>:DELevation
........................................236
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:A<ch>:DX
.................................................... 236
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:A<ch>:DY
.................................................... 236
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:A<ch>:DZ
.................................................... 236
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:ANTenna:COUNt
<NumberOfAntenna>
Set the numer of anntenas to be simulated.
Parameters:
<NumberOfAntenna> integer
Range:
1 to 4
*RST:
1
Example:
See
Example "Selecting an antenna pattern and body mask file"
Manual operation:
See
"Simulation Configuration > Receiver > Number of Anten-
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:ANTenna:DISPlay
<AntennaView>
Select the antenna characteristics that are currently visualized.
Parameters:
<AntennaView>
APOWer | APHase | BODY | POSition
*RST:
APOWer
Example:
See
Example "Selecting an antenna pattern and body mask file"
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:RECeiver[:V<st>]:ANTenna:V3D
<Visualize3D>
Activates the interactive 3D representation of the body mask or the power/phase distri-
bution the antenna.
Parameters:
<Visualize3D>
0 | 1 | OFF | ON
*RST:
0
Example:
See
Example "Selecting an antenna pattern and body mask file"
Manual operation:
See
Antenna Pattern and Body Mask