Remote-Control Commands
Satellite Navigation
293
User Manual 1178.6379.02 ─ 01
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:SVID<ch>:QZSS:SIMulated:CLOCk:TGD
<Tgd>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:SIMulated:CLOCk:TGD
<Tgd>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIMulated:CLOCk:TGD
<Tgd>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:BEIDou:SIMulated:CLOCk:TGD<s2us>
<Tgd>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIMulated:CLOCk:TGD
<Tgd>
Sets the group delay.
Parameters:
<Tgd>
float
Range:
INT_MIN to INT_MAX
Increment: 1E-15
*RST:
0
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L2C
<IscL2C>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L2C:UNSCaled
<IscL2C>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L5I
<IscL5I5>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L5I:UNSCaled
<IscL5I5>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L5Q
<IscL5Q5>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L5Q:UNSCaled
<IscL5Q5>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L1CA:UNSCaled
<IscL1CA>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:NMESsage:CNAV:CCORection:ISC:
L1CA
<IscL1CA>
Sets the inter-signal corrections (ISC) parameters of the GPS CNAV message.
Parameters:
<IscL1CA>
integer
Range:
-4096 to 4095
*RST:
0
Manual operation:
See
19.12.2 Pseudorange Commands
[:SOURce<hw>]:BB:GNSS:SVID<ch>:QZSS:PRERrors:MODE
.......................................... 295
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:PRERrors:MODE
....................................... 295
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:PRERrors:MODE
.....................................295
Navigation Message Configuration