Remote-Control Commands
Satellite Navigation
387
User Manual 1178.6379.02 ─ 01
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:ONTime
<OnTime>
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:OFFTime
<OffTime>
Sets the number of chips during which the marker output is on or off.
Parameters:
<OffTime>
integer
Range:
11 ns to 182.2 ms
*RST:
11 ns
Default unit: s
Example:
See
Chapter 19.18, "Marker Settings"
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PATTern
<Pattern>
Defines the bit pattern used to generate the marker signal.
Parameters:
<Pattern>
64 bits
Example:
See
Chapter 19.18, "Marker Settings"
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:DIVider
<Divider>
Sets the divider for pulse marker mode (
PULSe
).
Parameters:
<Divider>
integer
Range:
2 to 1024
*RST:
2
Example:
See
Chapter 19.18, "Marker Settings"
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal. The pulse frequency is
derived by dividing the symbol rate by the divider.
Return values:
<Frequency>
float
Example:
See
Chapter 19.18, "Marker Settings"
Usage:
Query only
Manual operation:
See
Marker Settings
