Preparing for Use
R&S
®
SZU100A
10
Manual 1425.3061.02 ─ 04
5
Preparing for Use
This section explains how to take an R&S
SZU IQ Upconverter into operation. It
includes the controls and connectors of the R&S
SZU, and provides all the infor-
mation necessary for connection.
For information on the equipment required for a basic test setup, see
5.1
Unpacking and Checking the R&S
SZU
To remove the instrument from its packaging and to check the equipment for com-
pleteness, proceed as follows:
1. Unpack the R&S
SZU and the other contents of the shipping container.
2. Check the equipment for completeness using the delivery list.
3. Remove the protective cap from the waveguide port at the front of the
R&S
SZU. Inspect the instrument carefully, to make sure that it has no dam-
age from shipment.
If there is any damage, immediately contact the freight forwarder, who has
delivered the instrument.
Packaging material
It is recommended that you retain the original packaging material. If the
R&S
SZU needs to be transported or shipped later, you can use the mate-
rial to prevent control elements and connectors from being damaged.
Equipment returned or sent in for repair must be packed in an appropriate
packaging, if the original packaging is no longer available.
Also use the packaging material for storage of the instrument and the
accessories.
Unpacking and Checking the R&S
SZU
