Preparing for Use
R&S
®
TSMA
10
Getting Started 1177.5604.02 ─ 10
4.1
Unpacking the Instrument
The following section describes how to setup the instrument.
Risk of instrument damage due to inappropriate operating conditions
Specific operating conditions are required to ensure accurate measure-
ments and to avoid damage to the instrument. Observe the information on
appropriate operating conditions provided in the basic safety instructions
and the instrument's data sheet.
Check the equipment for completeness using the delivery note and the accessory
lists for the various items. Check the instrument for any damage. If there is dam-
age, immediately contact the carrier who delivered the instrument. Make sure not
to discard the box and packing material.
Packing material
Retain the original packing material. If the instrument needs to be transpor-
ted or shipped later, you can use the material to protect the control ele-
ments and connectors.
Accessory list
The following items are included with shipment of the R&S TSMA:
●
SCAN Link interconnection cable (SCAN <-> SCAN)
●
12 V DC power supply cable with a cigarette lighter connector
●
Wide range RF paddle antenna (700 MHz to 2600 MHz)
●
Active GPS patch antenna
●
Two stub antennas for WLAN/Bluetooth
®
Unpacking the Instrument
