Instrument Tour
R&S
®
TSMA
33
Getting Started 1177.5604.02 ─ 10
LAN
The LAN connector provides a high-speed 100 Mbit Ethernet interface with an RJ
45 connector using IPv4. It is used to connect the R&S TSMA to a host PC in a
local network.
The LAN interface can be used for Remote Control / Remote Desktop Con-
nections. In this case, the device must not be in the "Scanner Only" mode.
Alternatively, it can also be used for distributed versions of R&S ROMES
and R&S NESTOR.
The LEDs on the LAN connector indicate the status of the connection to the host
PC. LED 1 (yellow, link status) is on the left side of the connector, LED 2 (green,
activity status) is on the right.
DC IN Connector
The DC IN connector is used to supply the R&S TSMA with DC power. A wide DC
input range 10 to 18
V / max. 4
A is supported.
Use only cable type with R&S No. 1523.7948.00 (included in delivery pack-
age).
RF IN Connector
The RF IN connector is the RF input of the R&S TSMA. The multi-band RF pad-
dle antenna (700 MHz to 2.6 GHz), which is included in the shipment of R&S
TSMA or any customer side RF source is connected to this SMA connector. The
maximum input power is +20
dBm/10
V
DC.
For the multi-band RF paddle antenna (700
MHz to 2.6
GHz), no adapter is
required.
Risk of instrument damage
Do not overload the maximum allowed input of 20
dBm.
Non-compliance destroys the input mixer.
Rear Panel
