Configuring the R&S
TSMA6
R&S
®
TSMA6
33
User Manual 4900.8057.02 ─ 06
LAN
1. Connect the R&S
TSMA6 LAN port with the host PC port.
2. Use the R&S
TSMA6 default IP settings, that is, the DHCP client. The R&S
TSMA6
and the remote host PC automatically negotiate the IP address.
Alternatively, use the fixed address.
3. Start a web browser via the R&S
TSMA6 web GUI and enter the following URL:
http://TSMA6-<xxxxxx>.local
(xxxxxx is the serial number of this specific
R&S
TSMA6)
Local access from the R&S
TSMA6 and Windows Explorer
► Open Internet Explorer using mouse, keyboard and monitor. The R&S
TSMA6 web
GUI opens automatically. If not, type the following URL:
http://localhost
6.1.2
Establish a Remote Desktop Connection
To establish a remote desktop connection, the following steps must be performed:
1. A WLAN/LAN connection between the R&S
TSMA6 and the remote PC has to be
2. On the external Windows PC, navigate to "Programs" > "Accessories" > "Remote
Desktop Connection".
3. In the "Remote Desktop Connection" window, click "Options".
4. In the "General" tab, enter following parameters:
● Computer: The input depends on selected connection type (see the
on page 32) and is as follows.
–
WLAN:
192.168.137.1
–
LAN: IP address of the R&S
TSMA6
NOTE
:
If you connect the R&S
TSMA6 LAN interface with a PC via LAN cable, the
IP addresses are negotiated automatically by default. No fixed IP
addresses are assigned. In this case, you can add the device name in the
"LAN" field. This requires a working DNS service.
● User name:
instrument
Accessing the R&S
TSMA6
