Update and Restore
R&S
®
TSMA6
58
User Manual 4900.8057.02 ─ 06
8. Click "Install".
Note:
Do not switch off or unplug from power while running firmware/software
update.
9. The state of the installation process is displayed in the "Status" column. The proc-
ess is finished when the status indicates "Ready…".
10. Press "Exit".
11. Reload the R&S
on page 62) and verify the installed firmware /software version in the
"Overview".
The R&S
TSMA6 is ready for operation.
7.1.2.3
Installation Using a USB Stick
The setup will be initiated via the web GUI of the R&S
TSMA6. In this case, the setup
file must be available in the root directory of a USB stick, which is connected to the
R&S
TSMA6.
If a restart is performed during the setup, the message
System is Restarting
is dis-
played in the status bar. For a short time, the web GUI is not accessible.
Do not interrupt the browser session on the remote PC. After a successful update, the
web GUI will be refreshed.
1. Connect mouse, keyboard to the USB ports and a monitor.
Firmware Update