Preparing for use
R&S
®
TSMA6B-BP
12
Manual 4900.9099.02 ─ 02
occur. Suitable AC power supplies are listed in the data sheet. They differ in the
output power:
●
R&S TSME-Z1 has an output power of about 30 W, sufficient for up to two
products, one TSME6 and one TSME30/44DC.
●
R&S TSMA6-Z1 has an output power of 105 W and is suitable for multiple
TSMx products.
1. Ensure that the required ratings listed in the data sheet are matched.
2. Connect the round connector to DC IN.
3. Insert the AC power plug into a power outlet with ground contact.
3.3
Inserting and removing the batteries
To insert the batteries
1. Press one battery bay lid and open it up.
2. Insert the batterie in the correct way (charge indicator facing up). Take care of
the nut in the battery and the pin inside the battery bay.
NOTE: Use only the battery type R&SMNT-BP99WH (order no. 3660.9109.02)
3. Close the lid until it clicks into place.
NOTE: The R&S TSMA6B-BP may be used only with closed battery lids.
.
To remove the batteries
1. Press one battery bay lid and open it up.
2. Remove the batterie.
3. Close the lid until it clicks into place.
.
For details about recharging and storing batteries, see
Inserting and removing the batteries
