Update and restore
R&S
®
TSMA6B
89
User Manual 4901.4026.02 ─ 01
The backup procedure takes up to 15 minutes.
During the backup the [Mode] LED is blinking red. In the web GUI, the following status
message will be displayed.
"Backup is in progress..."
The backup procedure has finished, when the [Mode] LED displays the normal operat-
ing state. The color of the LED depends on the state of the WLAN AP.
During the backup, do not interrupt the procedure or disconnect the power supply.
8.7.2
Restore
With the RESTORE button, it is possible to restore the system partition R&S TSMA6B
to the user backup (see
on page 88) or to the factory backup,
if no user backup exists.
If a user backup exists, but you want to restore the factory backup, proceed as descri-
bed in
Chapter 8.7.3, "Restore factory backup"
To perform a restore, the RESTORE button must be pressed (more than 20
s) with a
round, blunt pen (diameter 1 to 2 mm). During the recovery process, the [Mode] LED is
blinking blue.
The RESTORE procedure takes up to 15 minutes!
During this time, do not interrupt the procedure or disconnect the power supply!
When the RESTORE procedure has been completed, the color of the [Mode] LED
depends on the state of the WLAN AP.
[Mode] LED
WLAN AP status
green
WLAN AP off
blue
WLAN AP on
Loss of user settings after RESTORE
Executing restore brings the R&S TSMA6B irreversible back to the condition of delivery
or any other subsequently stored backup version.
On the
c:\
drive, all user settings and installed programs since the last restore will be
deleted.
8.7.3
Restore factory backup
To restore the factory backup, perform the following steps.
1. Connect mouse, keyboard and monitor to the R&S TSMA6B.
User backup and restore
