Command reference
R&S
®
ZNB/ZNBT
1327
User Manual 1173.9163.02 ─ 62
Parameters:
<SweepDuration>
Sweep time. The minimum possible sweep time depends on the
other channel settings, in particular on the number of points
(
(
[SENSe<Ch>:]BWIDth[:RESolution]
ment delay for each partial measurement (
). Changing the duration leaves the number of
points unchanged but directly affects the delay.
Range:
Between minimum sweep time (for current channel
settings) and 100000 s
*RST:
Minimum sweep time (for *RST channel settings)
Default unit: s
Example:
SWE:TIME 1
Set a total sweep time of 1 s.
SWE:DWEL?
Query the delay for each partial measurement.
SWE:TIME 2
Increase the total sweep time to 2 s.
SWE:DWEL?
Query the meas. delay for each partial measurement again. The
delay is increased by 1 s divided by the total number of partial
measurements per sweep.
Manual operation:
See
[SENSe<Ch>:]SWEep:TIME:AUTO
<Boolean>
When enabled, the (minimum) sweep time is calculated internally using the other chan-
nel settings and zero delay (
Note:
The automatically calculated sweep duration is ignored for the sweep types
).
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean>
ON | OFF - turn the automatic calculation of the sweep time on
or off.
OFF is also set if the sweep duration or delay is set explicitly
using
*RST:
ON
Example:
SWE:TIME 1
Set a total sweep time of 1 s.
SWE:TIME:AUTO?
A query returns the value
1
.
Manual operation:
See
SCPI command reference
