GUI reference
R&S
®
ZNB/ZNBT
745
User Manual 1173.9163.02 ─ 62
The different color reaches from the last passed measurement point before the start of
the failed segment to the last failed measurement point in the segment. Consequently,
the colorized trace segment can begin before the begin of the failed range and can end
before its end.
Remote command:
Display color scheme only!
DISPlay:CMAP:LIMit:FCOLorize[:STATe]
Limit Test > Use Trc Color for Limit Lines
Assigns the trace color to all limit line segments associated with the trace. All other
limit line color definitions are ignored.
Remote command:
Display color scheme only!
General > Trace Colors per Diagram
Controls the color of traces that are created in a diagram or moved to another diagram.
●
If "Trace Colors per Diagram" is enabled (factory preset), all diagrams use the
same trace colors. The first trace in each diagram gets trace color 1, the second
trace color 2 etc. (cyclically).
In particular, if a trace is removed from a diagram, then all traces in this diagram
that were created after the removed one, will change their color. And if this trace is
moved to another diagram, its color typically changes as well.
●
If "Trace Colors per Diagram" is disabled, then the traces are colored with trace
colors 1 to 8 (cyclically) in the order they are created. No matter to which diagram
they are assigned.
All traces keep their original trace color (number).
Remote command:
Display color scheme only!
DISPlay:CMAP:TRACe:COLor[:STATe]
General > Same Color all Markers
Selects a common marker color, which is independent of the trace colors.
Display softtool
