Command reference
R&S
®
ZNB/ZNBT
1060
User Manual 1173.9163.02 ─ 62
CALCulate<Chn>:DLINe
<Position>
Defines the position (response value) of the horizontal line.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Position>
See list of parameters below.
Default unit: NN
Example:
*RST; :CALC:DLIN 10
Define the position of the horizontal line in the default dB Mag
diagram at +10 dB.
CALC:DLIN:STAT ON
Display the defined horizontal line.
Manual operation:
See
CALCulate<Chn>:DLINe:STATe
<Boolean>
Switches the horizontal line on or off.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean>
ON | OFF - horizontal line on or off
*RST:
OFF
Example:
See
Manual operation:
See
CALCulate<Chn>:FORMat
<Type>
Defines how the measured result at any sweep point is post-processed and presented
in the graphical display.
Note:
The analyzer allows arbitrary combinations of display formats and measured
quantities; see
Chapter 5.3, "Format softtool"
CALCulate<Ch>:PARameter...
commands. Nevertheless, it is advisable to check
which display formats are generally appropriate for an analysis of a particular mea-
sured quantity; see
Chapter 4.2.3.3, "Measured quantities and trace formats"
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI command reference