Command reference
R&S
®
ZNB/ZNBT
1068
User Manual 1173.9163.02 ─ 62
CONFigure:CHANnel<Ch>:MEASure[:STATe]
<Boolean>
Enables or disables the sweep in channel no.
<Ch>
. This command can be used to
restrict the measurement in a subset of channels in order to optimize the measurement
speed.
Suffix:
<Ch>
.
Number of an existing channel.
Parameters:
<Boolean>
ON | OFF
*RST:
ON (all existing channels)
Example:
*RST; :CONFigure:CHANnel2 ON; CHANnel3 ON
Create channels 2 and 3, in addition to the default channel no.
1. The analyzer performs sweeps in all three channels.
CONFigure:CHANnel:MEASure:ALL OFF
Disable the measurement in all channels
CONFigure:CHANnel2:MEASure ON
(Re-)enable the measurement in channel no. 2. The analyzer
measures in channel 2; the channels no. 1 and 3 are not mea-
sured.
Manual operation:
See
CONFigure:CHANnel<Ch>:NAME
<ChannelName>
Assigns a name to channel number
<Ch>
. The channel must be created before
ON
). Moreover it is not possible to assign the
same name to two different channels.
returns a list
of all defined channels with their names.
Suffix:
<Ch>
.
Number of an existing channel.
Parameters:
<ChannelName>
Channel name, e.g. 'Channel 4'.
*RST:
'Ch1'
Example:
See
Manual operation:
See
CONFigure:CHANnel<Ch>:NAME:ID?
<ChannelName>
Queries the channel number (numeric suffix) of a channel with known channel name. A
channel name must be assigned before (
<ChannelName>
).
channels with their names.
Suffix:
<Ch>
.
Channel number. This suffix is not relevant and may be omitted
(the command returns the actual channel number).
SCPI command reference
