Command reference
R&S
®
ZNB/ZNBT
1079
User Manual 1173.9163.02 ─ 62
Return values:
<Results>
Measured voltages, either a single value or a comma-separated
list.
Default unit: V
Usage:
Query only
Options:
R&S ZN-B15/Z15 Var. 03
Manual operation:
See
CONTrol<Ch>:GPIO<Port>:SHUNt?
Returns the shunt resistance (in Ω) selected by the analyzer firmware for the config-
ured current range (see
).
The dependency between current range and shunt resistance is displayed in the tables
below.
Note:
The high resistance configuration of pins 9 and 10 requires FPGA version 6.1.0
or higher. For older versions of the R&S ZN-B15/Z15 Var. 03, pins 9 and 10 have the
same current range as pins 1 to 8.
Suffix:
<Ch>
.
Channel number
<Port>
GPIO port 1, ..., 10
Example:
:CONTrol1:GPIO1:RANGe 20mA
:CONTrol1:GPIO1:SHUNt?
Returns 10 [Ω]
:CONTrol1:GPIO1:RANGe 2mA
:CONTrol:GPIO1:TEST:CLOCk:SHUNt?
Returns 100 [Ω]
:CONTrol1:GPIO1:RANGe 200uA
:CONTrol:GPIO1:SHUNt?
Returns 1000 [Ω]
:CONTrol1:GPIO9:RANGe 0
:CONTrol:GPIO9:SHUNt?
Returns 100000000 [Ω]
:CONTrol1:GPIO9:RANGe 100mA
:CONTrol:GPIO9:SHUNt?
Returns 1 [Ω]
Usage:
Query only
Options:
R&S ZN-B15/Z15 Var. 03
Manual operation:
See
Table 7-11: Pins 1 to 8
Range
2 μA
20 μA
200 μA
2 mA
20 mA
Shunt
100 kΩ
10 kΩ
1 kΩ
100 Ω
10 Ω
SCPI command reference
