Command reference
R&S
®
ZNB/ZNBT
1248
User Manual 1173.9163.02 ─ 62
‘PABS’
9-term correction factors, defined for the lowest source port
<SourcePort> for each SMARTerCal; <LoadPort> is ignored
'L1', 'L2'
9-term correction factors, defined between the source port
<SourcePort> and the load port <LoadPort>
Range:
The error terms are dimensionless complex num-
bers.
*RST:
n/a
<SourcePort>
Source port number
<LoadPort>
Load port number. If the error term is not related to the load port,
a dummy number can be used; e.g.
CORR:CDAT
'REFLTRACK', 1, 0
<CorrectionData>
Correction data set (one complex number per sweep point) to be
transferred to the analyzer either in ASCII or block data format,
depending on the current
tion data set is assigned to the specified channel, error term,
source and load port.
This parameter must not be used for queries.
Example:
See
[SENSe<Ch>:]CORRection:COLLect:SAVE:
The different calibration types of the analyzer provide the following error terms:
Calibration type
Parameters in
[SENSe<Ch>:]CORRection:
COLLect:METHod:DEFine
Available error terms (depending on port num-
bers)
One-port normalization (reflection)
using an open or a short standard
REFL, RSHort
'REFLTRACK'
Full one port ("Refl OSM")
FOPort
'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK'
Two-port normalization
FRTRans
'TRANSTRACK'
One path two port
OPTPort
'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'TRANSTRACK'
TOSM
TOSM
'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'LOADMATCH', 'TRANSTRACK'
TOM, TSM, TRM, TRL, TNA
TOM | TSM | TRM | TRL | TNA
'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'LOADMATCH', 'TRANSTRACK' (for reading and
writing)
'G11' ... 'G22' and 'H11', 'H12', 'H22' (for reading
only; the 'H21' matrix elements are normalized to
1)
[SENSe<Ch>:]CORRection:CONNection
<ConnectorName>[, <Mode>[, <Gender>[,
<RelPermittivity>[, <RefImpedance>]]]]
Configures the user-defined connector types.
SCPI command reference