Command reference
R&S
®
ZNB/ZNBT
1423
User Manual 1173.9163.02 ─ 62
ON (1)
*RST
and
SYSTem:PRESet
restore the user preset file selected
using
, if this file is available and
valid. Otherwise, they perform a factory preset.
Manual operation:
See
SYSTem:PRESet:SCOPe
<Scope>
Specifies whether the preset actions affect all open recall sets, or only the active recall
set.
command. The
*RST
com-
mand always resets all open recall sets.
Parameters:
<Scope>
ALL | SINGle
ALL
All open recall sets are deleted and a new recall set"Set1" is cre-
ated according to the current preset mode.
See
SINGle
The active setup is reset according to the current preset mode;
the name of the active setup and the parameters of all other set-
ups remain unchanged.
Example:
See
Manual operation:
See
SYSTem:PRESet:STARt
<Boolean>
Defines whether the analyzer firmware always starts with the configured system preset
(factory or user defined) or with the previous state. This is a global setting.
Parameters:
<Boolean>
ON
The FW always starts with the configured system preset.
See
OFF
The analyzer firmware recalls the previous state, i.e. the settings
that were persisted during the previous shutdown.
Manual operation:
See
SYSTem:PRESet:USER:CAL
<PresetUserCal>
Selects a calibration from the calibration pool that shall be restored during a user-
defined preset.
SCPI command reference
