GUI reference
R&S
®
ZNB/ZNBT
570
User Manual 1173.9163.02 ─ 62
Figure 5-46: Stimulus Dialog: Power Sweep
Except for the "Enter & Display" properties, all these parameters can also be set in the
. Depending on the channel's
, a different set of parameters
can be modified.
Table 5-3: Parameters for frequency sweeps
Lin/Log Freq Sweep
CW Mode Sweep
Time Sweep
x
x
x
x
–
–
x
–
–
x
x
x
x
x
x
Enter & Display
The "Enter & Display" combo boxes in the "Frequency Sweep" and "Power Sweep"
sections of the "Stimulus" dialog control how frequency and power values are entered
and displayed in this dialog.
You can either take the channel perspective (f
b
, P
b
), or the perspective of a particular
source or receiver. The two can be used interchangeably to define the sweep, if the
user-defined linear transformation relating them is not constant.
Note:
For frequency sweeps, source/receiver-specific linear frequency transformation
are enabled with option R&S
ZNB/ZNBT-K4 (see
Chapter 4.7.4, "Frequency conver-
5.12.2.3
Define Parallel Measurement dialog
With the R&S
ZNBT or a 4-port R&S
ZNB with internal second source, you can mea-
sure multiple DUTs (or multiple paths of a single DUT) in parallel. The "Define Parallel
Measurement" dialog allows you to configure these DUTs and to declare the connec-
tions between physical VNA ports and DUT ports. Furthermore it provides convenient
access to port-related settings.
Channel Config softtool