GUI reference
R&S
®
ZNB/ZNBT
643
User Manual 1173.9163.02 ─ 62
D1, D2
The "D1" (and "D2") buttons are enabled as long as the selected deembedding/embed-
ding network is defined using Touchstone files.
When loading a touchstone file, the analyzer by default assumes odd ports left (VNA
side), even ports right (DUT side). However, it is also possible to instruct the analyzer
to assume an "Increasing Port Sequence", i.e. that the low port numbers are on the
VNA side. Furthermore it is possible to "Swap Gates", i.e. to instruct the analyzer to
swap the VNA and DUT side.
Note:
The loaded file is stored in the active recall set. Persisted recall sets contain the
full de-/embedding data so that they can be transferred to other instruments.
Remote command:
5.13.7
Balanced tab
Selects 4-port transformation networks for balanced port deembedding/embedding,
defines their parameters, assigns them to a balanced port and enables embedding.
Use the complementary dock widget to create
and to activate or deac-
tivate dembedding/embedding for selected balanced ports (see
Background information
Chapter 4.6.2.10, "Combining Several de-/embedding networks"
Offset Embed softtool
