Manual-7
헁
HlGH-MID MUTE switch:
Removes all signal from the High-Mid Output when pressed to the
in
position.
This control is
disabled in 4-Way mode.
헂
HlGH-MID DELAY control:
This control adds from 0 to 2 ms of time Delay to the High-Mid Output only.
This control is
disabled in 4-Way mode.
헃
HlGH-MID/HIGH crossover frequency selector:
This control sets the crossover Frequency between the High-Mid and
High Frequency Outputs.
This control is disabled in 4-Way mode.
헄
HIGH LEVEL control:
This controls the Level of signal to the High Output only.
헅
POWER switch and indicator:
Two choices: on or off. If the power supply is plugged in, this yellow LED is lit, and the
POWER button is depressed, then the unit ready to operate.
See the Following Pages for Mono 4- or 5-Way Installation.
Mono 4-Way Switch Instructions
1. Be sure all power and audio is turned off. Remove the top
cover of the AC 23B.
2. Locate the 4-WAY/5-WAY switch (see diagram).
3. Move the switch from the 5-WAY position to 4-WAY.
4. Replace the cover. The AC 23B is now set for Mono 4-
Way Mode. The HIGH-MID OUTPUT duplicates the MID
OUTPUT frequencies with a different low pass setting as
determined by the HIGH-MID / HIGH FREQUENCY
control, and is not normally recommended for use since the
tweeter crossover point will be inaccurate.
This operation must be reversed to operate the unit
in either Stereo 3-Way or Mono 5-Way Mode.
2W
3W
CHANNEL 2
STEREO
CHANNEL 1
STEREO
MONO
2W
3W
STEREO
Monoing the Low Outputs
It is possible to mono the Low Frequency Outputs of the
AC 23B by an internal jumper. Set both Low Delays to “0”.
1. Remove the power cord and the AC 23B top cover.
2. Move the header to the J10 mono sum position.
3. Moving the header to the SHIP position puts the Low
Outputs back in stereo, as shipped from the factory.
4. Replace the cover.
The mono output is now at Channel 1 LOW OUT.
Channel 2’s LOW OUT is unused.
