Manual-6
©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL 425-355-6000 FAX 425-347-7757 WEB www.rane.com
112243
CASCADE OUT / RAD PORT
This port functions as a CASCADE OUT port when con-
nected to the CASCADE IN port of a Rane AM1 or AM2 (sold
separately). Connect the CASCADE OUT port of an AM2 to
the CASCADE IN port of another automixer, to add it’s Mic
Inputs and all upstream inputs into the automatic gain-sharing
mix of the downstream mixer. When cascaded, the signal on
the CASCADE OUT port is
unaffected
by the gray OUTPUT
LEVEL control.
This port functions as a RAD Port when connected to a
Rane Mongoose (sold separately). The RAD port contains a
Rane-specific digital audio transport protocol allowing audio
delivery to a CobraNet™ digital audio network or another Re-
mote Audio Device via a Rane Mongoose. The audio exiting the
RAD port contains the Main Mix and is
attenuated
by the gray
OUTPUT LEVEL control.
For inquisitive technophiles, RAD Port audio is 24-bit,
48 kHz, fixed-point.
CobraNet is a trademark of Cirrus Logic Inc.
CASCADE
RAD PORT
USB
DATA
OUTPUT
MIC INPUTS
1
2
3
4
5
6
7
8
100-240V
13 WATTS
50/60 Hz
MADE IN
U.S.A.
RANE CORP.
ACN 001 345 482
AM2
MIC +48V MIC +0V LINE
MIC +48V MIC +0V LINE
MIC +48V MIC +0V LINE
MIC +48V MIC +0V LINE
IN
OUT
USB
LOCATE
FAULT
POWER
THIS DEVICE COMPLIES
WITH PART 15 OF THE FCC
RULES FOR A CLASS 'B'
COMPUTING DEVICE.
24 VDC @ 100 mA
CLASS 2 WIRING
MIC LINE
RAD PORT Status indicators are defined below:
AUDIO Tx
LED – lights green when audio is received by a
Mongoose or AM2. If this indicator is off, either the cable is
bad, or there is a communications error between the devices
(see COMM LED below).
AUDIO Rx
LED – lights green when the RAD Port successfully
receives audio from the Mongoose or cascaded AM2. If this
indicator is off, you may have a bad cable, or the device at the
other end of the cable is not powered or connected.
COMM
LED – lights green when communication is established
between the Mongoose or a cascaded AM1 or AM2. This
indicator turns off if the RAD Port cannot communcate with
the other device for some reason – likely due to a faulty cable.
POWER
LED – lights green when the RAD Port is receiving 24
volt power from the Mongoose or cascaded device. This also
indicates that the twisted pair for power within the cable is
wired and crimped properly. If the Power LED is off and the
other end of the cable is plugged into a powered device, there
is a problem with the cable.
