CP66
Installation Manual
13
PAGER2
BUSY
CHIME
READY
PAGER2 Paging Station
The PAGER2 paging station is an advanced digital pager
that allows the user to easily select any combination of
Zones for paging right at the device itself. Indicators on
the PAGER2 tell the user if the Zone is
ready
or
BuSy
(already being paged by a higher-priority Input) and when
the
cHiMe
has completed (if enabled).
Two group buttons are provided to give quick access
to commonly-used zone combinations, for example “All
Outdoor Zones” or “Dining Areas.” To store a group, select
your active Zones, hold the
grOuP 1
or
grOuP 2
button
until the LED flashes, then release.
The Lexan overlay on the PAGER2 has slots on either
side to allow insertion of printed labels, letting you set
custom names for your Zones and Groups. To easily make
labels with any printer, download the CP66 Labels PDF at
rane.com/cp66.html
.
A tool is included in the shipping box to remove the
locking mechanism from the Neutrik jack so that the mi-
crophone may not be removed or stolen. The bottom panel
of the PAGER2 can also be removed to allow the entire
paging station to be securely fastened to a desk or table or
held down via keyholes.
The PAGER2 uses a RJ-45 terminated connection for
power, data, and audio over a single shielded CAT 5e cable
up to 500 feet (152 meters). It accepts any standard micro-
phone, and has built-in +24V phantom power as well as
a selectable 13 dB pad for high-output microphones. The
rear panel has indicators to troubleshoot any CAT 5 cable
failure.
The sturdy steel chassis measures 4.5"w x 1.9"h x 6"d
(15.3w x 4.6h x 11.3d) and weighs 20 ounces (567 grams).
