11
Limiter Threshold
(
???
)
The limiter ensures the output audio signal
does not exceed this volume level:
-60.0
to
0.0 dB
(default:
0.0 dB
).
Output Mode
(
Mode
)
(Zone 6 only)
This determines whether Zone 6’s output
signal is stereo (left and right) (
Stereo
) or
mono with two-way crossover (
X-Over
).
Note
: If a device (e.g., a power amplifier)
later in the signal path than Zonetech is
using a limiter, the limiter with a lower
threshold will determine the maximum level.
Tip
: If you are using a subwoofer and main
loudspeaker with this zone, use the mono
setting, and use the
X-Over Freq
,
Low
Level
, and
High Level
settings to manage
the signal.
X-Over Frequency
(
X Freq
)
(Zone 6 only)
This determines the frequency at which the
low frequencies and high frequencies are
split between the subwoofer and main
loudspeaker:
80
–
300 Hz
(default:
125 Hz
).
X-Over Low Level
(
XL Level
)
(Zone 6 only)
This is the output volume level of the audio
frequencies below the crossover frequency:
-10.0
to
+6.0 dB
.
Tip
: This is essentially the master volume of
the Zone 6 subwoofer.
X-Over High Level
(
XH Level
)
(Zone 6 only)
This is the output volume level of the audio
frequencies above the crossover
frequency:
-10.0
to
+6.0dB
.
Tip
: This is essentially the master volume of
the Zone 6 main loudspeaker.
Summary of Contents for Zonetech
Page 1: ...UserGuide English 3 25 Appendix English 26 27...
Page 2: ...2...
Page 28: ...rane com Manual Version 1 0...