Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
16.)
Install the hydraulic pump into the battery box, check all nuts holding wires, overtightening can break
the housing. 2 Bolts secure the pump through the bottom of the battery box.
17.)
Atatch the hose to the hydraulic pump.
18.)
Set the trailer deck on top of the frame.
19.)
Line up the tabs at the rear of the deck and insert the pivot bolts, tighten the bolts but leave space
between the tabs nd frame so the deck can swivel up and down freely.
20.)
Slide the battery box to approximately 15-20cm away from the deck and tighten the 2 retaining bolts.
