3 / 6
Programming Instructions
How To Use
UNLOCK the door from inside
UNLOCK the door from outside
LOCK the door from outside
LOCK the door from inside
Master/ User
code
Rotate the thumb turn to
Unlock position.
Enable Auto Lock
After Auto Lock is enabled, the bolt
will automatically extend in 30 seconds
after unlocking to lock the door.
(see Quick Set Up for how to enable this function)
One-touch Locking
Press any key on
keypad for 2 seconds.
Rotate the thumb turn to
Lock position.
Definitions
A. Master Code
The master code is the administrative code for
program lock functions. It will also unlock the door.
The default master code is 12345678.
For security reason, the default master code dose not
program the lock. You must change it to a code of
your own prior to programming.
83618
137192
14710
password
Random digits
C. Wrong Entry Limit
After 10 unsuccessful attempts at entering a
valid PIN code, the unit will shut down for 3 minuets.
1 2 3 4 5 6 7 8 9
1
2
3
4
5
6
7
8
9
2
2
2
2
2
2
2
3
8
6
5
If
Then
and
3
8
1
9
6
5
1
9
3
8
6
5
a. Forward number sequence
b. Backward number sequence
c. Repeat number sequence
d. Contain existing code sequence
Code is 4-10 digits.
Both master code and user code do not support the
following sequence.
B. Code Format
IMPORTANT: READ this before proceeding to programming.
E. Battery Indicator
If you hear 10 beeps corresponding with 10 red flashes after
pressing any key or lock and unlock the door, that's an
indication that the batteries need to be replaced soon. Please
replace with 4 new AA alkaline batteries and
do not mix old and new batteries. All settings are r etained
in the memory when the batteries are removed and replaced.
F. Key Override
Key Override can be used to gain access when the batteries
are completely dead or when no valid User Code is known.
Please keep at least one copy of the backup key in secure
location outside of your place.
D. Unlock with Fake code
User can prevent pin code exposure from strangers by
entering random digits before or after pin code.
2 2
B. User Code
The Master Code is used for programming and for
feature settings. It will also unlock the lock.
The default master code is 12345678.
This code must be changed prior to programming the
lock.
