4 / 6
Settings
Master Code
Auto Lock
Silent Mode
Wrong Code Entry Limit
Vacation Mode
Factory Defaut
12345678
Disabled
Disabled
10 times
Disabled
Factory Default Settings
Safety Warnings
Protect your User Codes and Master Code.
Restrict access to your lock’s interior assembly and routinely check your settings to ensure they have not been altered
without your knowledge.
Proper cleaning and maintenance of your lock ensures it will continue to work as it should.
Do not apply cleaner or detergent directly to any part of the lock.
The RZ-A meets IP54 water-resistance. It can withstand water splashes ; however, it is not waterproof.
Do not let water and liquids get into the lock.
Avoid exposure to direct sunlight. Long-term exposure to direct sunlight may damage the lock.
The temperature range of the RZ-A is between -4°F to 131 F.
Quick Set Up
IMPORTANT:
Each programming steps needs to be completed within 5 seconds.
If you hear 5 rapid beeps with flashing red lights, it indicates entry error or time-out. Please start over.
B. Add User Code
Up to 20 User Codes can be stored.
The default Master Code is 12345678. Please change it to a code of your own before programming.
C. Delete User Code
D. Enable Silent Mode
The beep sounds when pressing keypad can be muted. But you will still hear low battery and system alerts.
E. Disable Silent Mode
Automatically locks the deadbolt 30 seconds after unlocking. This feature is off by default.
G. Disable Auto Lock
J. Vacation Mode
This is a security feature for you when you are leaving your home for vacation or long trip. Enabling vacation mode will restrict
all user codes until master code is entered on keypad. If the lock is unlocked by thumb turn, the lock will sound an alarm.
H. Set Auto Lock Time Delay
You can set the Auto Lock time delay between 10 and 99 seconds.
I. Add One-Time Code
This code can only be used once and is automatically deleted when used.
A. Change Master Code
Master Code
New Master Code
Enter the New Code Again
1
Master Code
New User Code
Enter the New User Code Again
2
3
Master Code
Unwanted User Code
4
2
Master Code
4
1
Master Code
F. Enable Auto Lock
5
1
Master Code
5
2
Master Code
8
Master Code
Enter Duration Time (10 - 99)
7
Master Code
Enter the New User Code Again
6
Master Code
How To Reset
Step1
Step2
IMPORTANT:
Factory reset process is the same as door handing.
By performing the steps below, you will teach the lock the orientation of your door and delete all User Codes and
custom settings associated with the lock.
Keep the door opened and make sure the latch is retracted and thumbturn vertical.
Press and hold the reset button with one hand and the other hand take out one battery and place it back.
Step3
Do not release the reset button after battery is connected, instead, keep holding it until the latch automatically extend.
Enter the New User Code
