back
set
60 or 70 mm
35 mm to 50 mm
A
A
B
C
D
B
C
D
1"
25 mm
1
Prepare the door and check dimensions
Measure to confirm that the hole in the door
is 2-1/8" (54 mm)
Measure to confirm that the backset is
either 2-3/8" or 2-3/4" (60 or 70 mm)
Measure to confirm that the the hole in
the door edge is 1" (25 mm)
Measure to confirm that the door is 1-3/8"
to 2" (35 mm or 50 mm)thick
2
Install the latch and strike
Latch
Exterior Assembly
Battery Cover
Strike
A
E
K
B
F
G
B
C
D
Parts List
Drive-In Collar
Latch and
Strike Screws
Mounting Plate
Interior Assembly
Screws
Interior
Assembly
Mounting Plate
Screws
L
Backup Key
A
Is the door edge chiseled?
Is the backset 2-3/8”(60mm)?
Hold the latch in front of the door hole, with
the latch face flush against the door edge
YES
YES
NO
NO
Install latch in door with
supplied screws.
No adjustment is
required. Proceed
to next step.
Yes, it is 2-3/8” (60mm).
No, it is 2-3/4” (70mm)
Rotate and pull the
latch as shown
to extend latch.
Use a screwdirver to test if deadbolt works smoothy.
chiseled
not
chiseled
Make sure hole in door frame is drilled a
minimum of 1” (25 mm) deep.
H
I
I
H
C
or
or
1 / 6
Use a flathead screwdriver to remove
Rectangular face from latch and install
drive-in collar.
Install strike on the door frame
2-3/8" or 2-3/4"
1-3/8" to 2"
54 mm
2-1/8"
φ
2-3/4”
(70mm)
φ
2-3/8”
(60mm)
1
φ
2-3/4”
(70mm)
2
1
2
3
4
Actual Size
J
Install latch in door with wood
block and hammer.
Installation Guide
Latch/Strike
Screws(I)
Latch/Strike
Screws(H)
Mounting Plate
Screws
Strike
Interior Assembly
Screws
Mounting
Plate
Battery
Cover
Interior
Assembly
Exterior
Assembly
Backup Key
Latch
