14
20 mm
Cabinet door
Appliance
door
Slider
Slider guide
40 mm
5 mm gap
Fixing brackets
fig.4-14
Installing your fridge-freezer
1.
Fit the appliance towards the left-hand side of the
housing unit, leaving a gap of approximately 5 mm.
2.
This fridge-freezer has front adjustable feet, which can
be used to level the appliance.
Using a suitable spanner, adjust the feet. Turn the
spanner clockwise to raise the feet and counter-
clockwise to lower the feet (fig.4-13).
The appliance should be fl ush with the underside of the
housing unit.
3.
Fix the appliance to the top shelf of the housing unit.
This will help to keep the appliance vertically parallel
with the décor doors.
4.
Adjust the appliance so that it measures 40 mm
between the appliance front edge and the front edge
of the housing unit (fig.4-14). Fix the appliance in
position.
5.
Trim the side gasket to the appropriate size and insert it
into the 5 mm gap on the left-hand side of the appliance
(fig.4-15).
6.
Remove the screw caps and the screw (fig.4-16).
7.
Fix the bracket supplied with the fi xing kit into position
(fig.4-17).
8.
Fit the slider guides on the edge of the appliance doors
(there are 2 slider guides per door). Insert the sliders
into the slider guides.
9.
Mark the distance from the front edge of the furniture
door to the edge of the slider. This measurement should
be approximately 20 mm (fig.4-18).
10.
Fix the sliders into position; the screws must be fully
tightened.
11.
Check that both furniture doors open and close
properly without fouling on the cabinet.
IMPortant:
Make sure that the doors of the appliance
and the door seals are shutting properly against the body
of the fridge freezer.
To check, close the door seal onto a thin strip of paper
(about 25–50 mm wide) and confi rm that the seal grips the
paper.
Retaining
bracket
Gasket
Side gasket
fig.4-16
fig.4-15
fig.4-17
fig.4-18
ArtNo.600-0116 - BIFF - Adjusting the feet
fig.4-13
