4
ArtNo.313-0003
110 Induction hob display
�
�
�
�
�
Make sure that the base of the pan is clean and dry to prevent
any residue burning onto the hob panel. This also helps
prevent scratches and deposits.
Always use pans that are the same size as (or slightly larger
than) the areas marked on the hob. Using a lid will help the
contents boil more quickly.
Always take care before touching the surface, even
when the hob is turned off. It may be hotter than you
think!
The induction hob comprises of five cooking zones
containing induction elements with different ratings and
diameters
(Fig.2-4)
each with a pan detector and residual
heat indicator, and a hob control display.
The hob control display
(Fig.2-5)
informs you of the following
induction hob functions:
ArtNo.030-0007 Induction symbols
Pan detector
H
Residual heat indicator
A
Automatic heat-up
L
Child lock
Pan Detector,
ArtNo.030-0007 Induction symbols
IMPORTANT:
After use, switch off the hob element by its
control and DO NOT RELY on the pan detector.
If a cooking area is switched on and there is no pan in place
or if the pan is too small for the cooking area, then no heat
will be generated. The symbol [
ArtNo.030-0007 Induction symbols
]
will appear on the hob
control display; this is the “pan-missing symbol”. Place a pan
of the correct size on the cooking area and the [
ArtNo.030-0007 Induction symbols
]
symbol
will disappear and cooking can begin. After 10 minutes
without detecting a pan the cooking zone will switch off
automatically.
Table 2-1
shows the minimum pan sizes recommended for
each cooking zone.
Note:
Using pans with a base diameter smaller than those
recommended will result in a power reduction.
Residual Heat Indicator,
H
After use, a cooking zone will remain hot for a while as heat
dissipates. When a cooking zone is switched off the residual
heat indicator symbol [
H
], will appear in the display. This
shows that the cooking zone temperature is above 60°C and
may still cause burns. Once the temperature has dropped to
below 60°C the [
H
] will go out.
Automatic Heat-up,
A
This function is available on all of the cooking areas. It
allows rapid heating up of the element to bring the selected
cooking zone up to temperature. Once the zone is at the
required cooking temperature the power level will reduce
automatically to the preset level.
The function is selected by turning the control knob to the
‘A’ position. This can be selected by either turning the control
knob momentarily anti-clockwise from the zero position or
clockwise past the ‘9’ until the symbol [
A
] is shown on the
hob control display.
Fig.2-5
ArtNo.313-0002 - 110 induction hob rating
�����
�����
�����
�����
�����
Fig.2-4
ArtNo.051-0002 - Min pan diameter
������������
��������������������
�������������
����������
���������
������
����������
�����������
���
���
���
���
���
Table 2-1
