Rangemaster CLA60NGFBL/C, User Manual

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

21

All dimensions in millimetres

800

600

A

400

300

Gas inlet block

Fig. 7.5 

Points that must be checked during 
fixed gas connection assembly

The method used to assemble a fixed gas connection (gas 

connection made by threads, e.g. a nut) varies according 

to the country you are in. The most common parts for your 

country will be supplied with your appliance. Any other parts 

required can be supplied as spare parts.
During connection, always keep the nut on the gas manifold 

fixed while rotating the counter-part. Use appropriately-

sized spanners for a safe connection. For surfaces between 

different components always use the seals provided in the 

gas conversion kit.
The seals used during connection should also be approved 

to be used in gas connections. Do not use plumbing seals for 

gas connections.
Remember that this appliance is ready to be connected to the 

gas supply in the country for which it has been produced. 
The main country of destination is marked on the rear cover 

of the appliance. If you need to use it in another country, any 

of the connections in the figure below may be required. In 

such a case, contact local authorities to learn the correct gas 

connection.
The Cooker must be installed and maintained by a suitably 

qualified gas registered technician in accordance with current 

safety legislation.

n

WARNING: Do not use a naked flame to check for gas 

leaks.

Electrical Connection

All external wiring must comply with the IEE Regulations 

for the Electrical Equipment of Buildings. Connection to the 

electrical supply is via a plug and socket. 

n

WARNING: The electrical connection of this 

appliance should be carried out by an authorised 

service person or qualified electrician, according to 

the instructions in this guide and in compliance with 

the current local regulations. 

n

WARNING: THE APPLIANCE MUST BE EARTHED. 

• 

Before connecting the appliance to the power supply, 

the voltage rating of the appliance (stamped on the 

appliance identification plate) must be checked for 

correspondence to the available mains supply voltage, 

and the mains electric wiring should be capable of 

handling the appliance’s power rating (also indicated on 

the identification plate). 

• 

During installation, please ensure that isolated cables 

are used. An incorrect connection could damage your 

appliance. If the mains cable is damaged and needs to 

be replaced this should be done by a qualified person. 

• 

Do not use adaptors, multiple sockets and/or extension 

leads.