Rangemaster Classic Deluxe 90 Induction, User Manual & Installation & Service Instructions

26

INSTALLATION

Check the ap pli ance is electrically safe and gas sound when you have fi nished.

Make 10 complete (360º) turns clockwise. (This means 
turning and removing the levelling tool 20 times). 

Make sure you lower BOTH REAR ROLLERS. There are 
two adjusting nuts, one for each roller, at both the front 
bottom corners of the cooker.

Unfold the rear edge of pack base tray. Open the grill door 
and the Tall oven door. Grip under the control panel and 
lift the front of the cooker. 

Carefully push the cooker 
backwards off  the pack base. 
Remove the pack base tray. 
Position the cooker close to 
its fi nal position leaving just 
enough space to get behind 
it. 

Do not use the door handles or control knobs to 
manoeuvre the cooker. Use the hotplate and griddle bowl 
areas. 

Conversion to LP

If the appliance is to be converted to LP gas do the 
conversion at this point. See the conversion section of 
these instructions.

Levelling

You are recommended to use a spirit level on a shelf in one 
of the ovens to check for level.

Place the cooker in its intended position taking care not 
to twist it within the gap between the kitchen units as 
damage may occur to the cooker or the units.

The rollers can be adjusted to level the cooker. To adjust 
the height of the rear of the cooker use the levelling tool 
supplied to turn the adjusting nuts at the front bottom 
corners of the cooker.

Adjust the height of the front roller to level the cooker. 
Turn clockwise to raise the cooker and anticlockwise to 
lower.

When you are satisfi ed with the height and level raise the 
front of the cooker by one turn of the front roller adjuster. 
Screw down the front feet to meet the fl oor. Screw the 
front roller adjuster anticlockwise to raise the front roller 
so that the front of the cooker is supported on the feet, 
not the front roller, to prevent accidental movement of the 
cooker. 

Leave the levelling tool on the adjuster with the handle of 
the tool facing the rear of the cooker, so that the customer 
can use it if they wish to move the cooker.

Replace the drawer by locating on side runners and push 
in.

Fit the Handles

Remove the 4mm Allen screws from the doors with the 
hexagon key tool. Use the screws to fi t the door handles. 

The handles should be above the fi xings.

Remove the 4mm Allen screws from the top corners of the 
fascia and fi x the front handrail in position.

Fitting the splash back (optional)

Remove the two fi xing screws (3mm hexagonal socket 
head) and nuts that pass through the top of the rear fl ue 
grille. Hold the splash back in position. From the rear refi t 
the 2 fi xing screws and nuts.